Filter
Top Products
24
Connection
Before connection, read carefully the instruction manual for the device to be connected.
Turning off the power switch of the devices before connecting cables.
If any connection cable is not supplied with the device, or if no optional cable is available for connection of the
device, prepare a necessary system connection cable to suit the device.
Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. In
this case, a time base corrector (TBC) must be connected.
The projector accepts the following signals: video, S-Video, analog RGB and digital signals from the PC.
Some PC models cannot be connected to the projector.
The pin-out and signal names of the S-VIDEO IN terminal are shown in the diagram below.
The pin-out and signal names of the RGB2 input terminal are shown in the diagram below.
Outside view
Pin No.
Ground (color signal)
Luminance signal
Color signal
Signal
Ground
(luminance signal)
Outside view
Signal
R/P
R
G/G · SYNC/Y
P
B
SDA
HD/SYNC
VD
SCL
Pin No.
Before starting connection
and are not assigned.
~ , and are GND terminals.
and are effective if the PC has the corresponding
functions.