Filter
Top Products
50
On-screen menus
Basic operations on menu
screen
Press the “MENU” button.
The MAIN MENU appears on the screen.
Select the desired item with the or
button.
Selected items are displayed in blue.
Press the “ENTER” button to establish
your selection.
The submenu for the selected option will now
open. (Example: PICTURE Menu)
Highlight the desired adjustment item
with the or button, then change
or adjust the parameter value with the
or buttons.
For the items such as “COLOR”, “TINT”, “CONTRAST”
and “BRIGHT”, an individual adjustment screen with an
individual bar graph as shown below is displayed by
pressing the ENTER button.
• If no button is operated for approx. 5 seconds while the
individual adjustment screen is displayed, the screen
will return to the previous page.
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
SECURITY
:MENU SELECT
ENTER:SUB MENU
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
SECURITY
:MENU SELECT
ENTER:SUB MENU
PICTURE
PICTURE MODE DYNAMIC
COLOR 50
TINT 30
COLOR TEMP. DEFAULT
GAMMA 2.2
CONTRAST 32
BRIGHT 32
SHARPNESS 6
NOISE REDUCTION 2
DYNAMIC IRIS 1
:MENU SELECT
:ADJUST
CONTRAST 32
Returning to the previous
screen
• When the “MENU” is on the screen, pressing the
“MENU” button returns to the previous page.
• When the MAIN MENU is on the screen, pressing the
“MENU” button clears all menus from the screen.
Menu items shown in gray
characters
•
Some menu items may not be valid for certain signal
formats applied to the projector.
The menu items that cannot be adjusted or used are shown
in gray characters, and they cannot be selected.
Menu items setting
The bottom prompt line differs on each menu
depending on the selected menu option:
• A prompt “ CHANGE” appears when
changing the setting.
• A prompt “ ADJUST” appears for a
separate bar graph.
• When and buttons are displayed above or
under the items in the “OPTION” screen, they
indicate that there are more adjustment (items).
Resetting to the factory
default
STD (standard) button is used to reset all of the
projector adjustment values to the default levels which
were set at the time of shipment from the factory. It is
pressed after the respective adjustment mode screen
has been displayed.
• When the Menu screen is displayed:
A “STD” indicator appears on the upper right corner
of the menu.
PICTURE STD
PICTURE MODE DYNAMIC
COLOR 50
TINT 30
COLOR TEMP. DEFAULT
GAMMA 2.2
CONTRAST 32
BRIGHT 32
SHARPNESS 6
NOISE REDUCTION 2
DYNAMIC IRIS 1
:MENU SELECT
:ADJUST