Filter
Top Products
97
Returning the network module setting back to the
factory setting
Using the following procedure, the user can return all settings of network module such as IP address, password
and Email setting to the factory setting.
Procedure of setting
Using the remote control “POWER” button, switch the power supply of the
projector to standby state.
Using something with a thin tip, press and hold the FUNCTION switch for three
seconds. The ON-LINE lamp blinks and turns off after 30 seconds or so.
Turn off MAIN POWER.
Turn on MAIN POWER while holding the FUNCTION switch pressed using
something with a thin tip.
When the ON-LINE lamp lights up, the operation is complete.
• Do not use a pencil or other fragile thing to depress the function switch.
Note
Image file control page
Folder selection button
This button specifies the folder to store
the image data.
Display selection button
This button selects the format of listing of
images stored in the network module.
Transmission button
Transfers an image stored in the PC to
the network module.
Display button
Displays an image stored in the network
module.
Delete file button
Deletes an image stored in the specified
folder of the network module.
• The format of images is compatible with BMP, JPEG and PNG.
However, some images may not be displayed because of more than one format existing in JPEG and PNG
images.
• Pixels of an image correspond to horizontal 1 024 dots times vertical 768 dots.
• The system can display 65 536 colors.
Note