13
Preparation
12
#Remote control signal receptor
(page 20)
$Security lock
This can be used to connect a
commercially-available theft-
prevention cable (manufactured
by Kensington). This security lock
is compatible with the Microsaver
Security System from
Kensington. Contact details for
this company are given below.
Kensington Technology Group
ACCO Brands Inc.
2855 Campus Drive
San Mateo, CA 94403 USA
Tel (650)572-2700
Fax (650)572-9675
http://www.kensington.com/
http://www.gravis.com/
NOTE:
BInformation given above may be
changed in future.
%Lamp unit holder
(page 49)
&Carrying handle
'Air outlet port
Do not cover this port.
When you change the direction of
the air flow out of the outlet port,
make sure that the MAIN
POWER is
“
OFF
”
and the
projector is cooled down.
WARNING
Do not bring your hands or other
objects close to the air outlet
port.
BHeated air comes out of the air
outlet port. Do not bring your
hands or face, or objects which
cannot withstand heat close to
this port, otherwise burns or
damage could result.
NOTE:
BDuring projection of an image, the
cooling fan will operate, emitting
a small noise as it operates.
Turning the lamp on or off will
cause this noise to increase a
little.
BBy using the OPTION2 menu to
set “LAMP POWER” to
“
LOW
”
,
the operating sound of the fan
can be reduced. (Refer to page
41.)
Projector <Back and bottom>
Location and function of each part
#Projector control panel
(page 14)
$Focus ring
(page 27)
%Air inlet ports
Do not cover these ports.
&Leg adjuster buttons(L/R)
(page 26)
These buttons are used to unlock
the front adjustable legs. Press to
adjust the angle of tilt of the
projector.
'Front adjustable legs(L/R)
(page 26)
(Projection lens
)Lens cover
*Zoom knob
(page 27)
+Remote control signal receptor
(page 20)
,Air filter
(page 48)
-Connector panel
(page 16)
.Power input socket (AC IN)
(page 26)
The accessory power cord is
connected here.
Do not use any power cord other
than the accessory power cord.
/MAIN POWER switch
(pages 26 and 27)
0Speaker
Projector <Top, right and front>
#
$
'
(
)
&
'+*
,
%
%
/
0
.
&
-
'#
$
%
&