Filter
Top Products
28
Obtain the required input modules (sold separately) beforehand in accordance with the system input signal.
• Types of input module (sold separately)
• Input slot numbers
• The signal sources connected to the input modules can each be selected by specifying the respective
slot number using the input select buttons on the remote control unit or the projector operating panel.
For details on selecting the input source refer to page 40.
• Modules other than the optional specified ones cannot be inserted into the slots 1, 2, and 3.
Installing the input module
Input signal
Serial digital signal
Serial digital signal
HD Serial digital signal
SVGA,XGA,SXGA signals
Module No.
ET-MD95RGB
ET-MD95VM2
ET-MD95SD1
ET-MD95SD2
ET-MD95SD3
ET-MD95T
Input signal level
Video/Sync. signal input impedance : 75 Ω/1 kΩ
R/PRCr, B/PBCb : 0.7 V [p-p] or 1.0 V [p-p] with
BETACAM input
G/Y 0.7 V [p-p](1.0 V [p-p]when SYNC ON G/Y signal is input)
Composite sync/Separate sync : 0.6 V [p-p]-4.0 V [p-p]
with 75 Ω, TTL level with 1 kΩ
Analog RGB input signal
fH:
15 kHz—100 kHz, fV: 24 Hz—120 Hz,
dot clock frequency: 20 MHz—162 MHz
Color difference input signal
Applicable formats: 480i, 576i, 480p, 720/60p,
1080/60i(1035/60i)1080/50i, 1080/30p,
1080/25p, 1080/24p, 1080/24sF
Video / Y : 1.0 V [p-p], C : 0.286 V [p-p]
Cr / Cb : 0.7 V [p-p], Impedance : 75 Ω
Conforming to SMPTE259M
Conforming to SMPTE259M/SMPTE294M
Conforming to SMPTE292M
Conforming to TMDS
Video signal
RGB/YP
bPr/YCbCr
signal
Slot 1
Slot 2
Slot 3
The bays (slots) in which the input modules are inserted
are numbered 1, 2 and 3 in order starting from the top,
as shown in the illustration at left.
The slots can be used in any order, and the same type
of input module can be inserted into more than one slot
at the same time. In addition, the projector will
automatically detect which input module has been
inserted into which slot.
It is necessary to select VIDEO or Y/C input and adjust
the input signal after the input module has been
inserted.
NOTE