Filter
Top Products
53
• If the black portions of the picture are fractured or tinged with green, adjust the clamp position its optimum
state.
Adjustment procedure
Press the MENU button. ... The MENU screen will be displayed.
Press the UP ( ) and DOWN ( ) arrow buttons to select POSITION.
Press the ENTER button. ... The POSITION screen will be displayed.
Press the UP ( ) and DOWN ( ) arrow buttons to select CLAMP POSITION.
• The clamp position can be adjusted when an RGB signal has been input with the
analog RGB module (ET-MD95RGB)
Press the ENTER button. ... The CLAMP POSITION screen will be displayed.
Press the LEFT ( )and RIGHT ( ) arrow buttons to adjust.
• The adjustment values will change from 0 (min.) to 254 (max.)
Optimum value for clamp position adjustment
• If the black sections are fractured → The optimum value is when the fracturing of the black sections
is at a minimum.
• If the black sections are tinged with green → Optimum value is when the green portion turns black but is not
smudged.
The projector has a picture mute capability that allows you to put the image off instantaneously. To mute the
image, press the PIC-MUTE button on the projector or remote control. To reset picture mute, press the PIC-MUTE
button a second time.
Adjusting the clamp position
Picture mute function
NOTE