Filter
Top Products
40
Selecting the input signal
• The following remote control unit buttons and the INPUT button on the projector operating panel can be used to
switch between different input sources.
• The input source can be changed in the order INPUT 1 INPUT 2 INPUT 3 each time the INPUT button on the
projector operating panel is pressed.
• When using the video signal input module ( ET-MD95VM2), the input source will toggle between LINE
and Y/C input each time the above input selection buttons are pressed.
(Example) If the ET-MD95VM2 has been installed to slot 1.
When INPUT 1 of remote control (or INPUT button the projector operating panel) is pressed, LINE
input will be selected, and when it is pressed once more, Y/C input will be selected.
Selecting the system format
• When the SYSTEM SELECTOR button on the remote control unit or the projector operating panel is pressed, the
signal format will change as shown below depending on which input module is installed.
Remote control unit
or
RGB
INPUT 1
R G B : Invalid
INPUT 1
: Switches to slot 1
INPUT 2
: Switches to slot 2
INPUT 3
: Switches to slot 3
INPUT 2
INPUT 3
Projector
INPUT
NOTE
RGB signal input module RGB RGB REALITY YPBPR ¥
When 720p or 1080i signals are input
ET-MD95RGB
¥When set at AUTO1
AUTO1 NTSC PAL SECAM NTSC4.43 PAL60
¥When set at AUTO2
AUTO2 NTSC PAL-M PAL-N
¥When set at YCbCr
AUTO 480i 576i
Serial digital input module
ET-MD95SD1 AUTO 480i 576i
ET-MD95SD2 AUTO 480p 480i 576i
ET-MD95SD3 AUTO 1080/60i 1035/60i 720/60p 1080/24p
1080/24sF 1080/25p 1080/30p 1080/50i
YCbCrRGB
¥When 480i or 576i or 480p signals are input
The SYSTEM SELECTOR button will not
function for signals other than the above.
Video signal input module
RGB REALITY
ET-MD95VM2
NOTE
• "480i" means a total of 525 lines, interlaced, and "576i" means 625 lines, interlaced, when the
lines hidden by vertical blanking are counted.
• For details of the AUTO1, AUTO2, or
YCbCr settings, see page 41.
• If you press the Standard (STD) button
while system format is being switched by
SYSTEM SELECTOR button, selection
will return to AUTO1, AUTO2, or AUTO.