Filter
Top Products
Technical Information
100 - ENGLISH
Appendix
REMOTE 2 IN terminal
It is possible to control the projector remotely (by external contact) from a control panel located away from
the projector where remote control signals cannot reach. Use the <REMOTE 2 IN> terminal on the side of the
projector to connect to the control panel.
Remote control External control
Remote control/External control
Standby ON
LAMP
RGB1 VIDEO
RGB2 S-VIDEO
DVI-D
Projector set up in a meeting room Control panel located in a different room
■ Pin assignments and signal names
D-Sub 9-pin (Outside view) Pin No. Signal name Open (H) Short (L)
(1) (5)
(6) (9)
(1) GND – GND
(2) POWER OFF ON
(3) RGB1 Other RGB1
(4) RGB2 Other RGB2
(5) VIDEO Other VIDEO
(6) S-VIDEO Other S-VIDEO
(7) DVI-D Other DVI-D
(8) SHUTTER OFF ON
(9) RST/SET
Controlled by remote
control
Controlled by
external contact
Attention
z
When controlling, make sure to short-circuit pins (1) and (9).
z
When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control
cannot be used.
The
POWER ON <
> button, the STANDBY < > button, the <SHUTTER> button, and the corresponding
RS-232C commands and network functions cannot be used either.
z
When pins (1) and (9) are short-circuited, do not short-circuit any pins from (3) to (7) with pin (1). The following
buttons on the control panel and the remote control cannot be used.
The POWER ON < > button, the STANDBY < > button, the <RGB1> button, the <RGB2> button, the
<DVI-D> button, the <VIDEO> button, the <S-VIDEO> button, the <SHUTTER> button, and the corresponding
RS-232C commands and network functions cannot be used either.
Note
z
For pin (2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER]. (
page 64)