Panasonic PT-DW730EL Projector Accessories User Manual


 
Using Remote control
20 - ENGLISH
Preparation
Using Remote control
Inserting and removing the
batteries
1) Open the cover.
(i)
(ii)
2) Insert the batteries and close the cover
(insert the
side rst).
z
When remove the batteries, perform the steps
in the reverse order.
Setting Remote control ID
numbers
When you use the system with multiple projectors,
you can operate all the projectors simultaneously or
each projector individually using single remote control,
if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same
ID number on the remote control.
The ID number of the projector is set to [ALL] by
the factory default. When using a single projector,
press the <ID ALL> button on the remote control.
How to set
1) Press the <ID SET> button on the
remote control.
2) Within ve seconds, press the two-
digit ID number set on the projector
using the number (<0> - <9>) button.
Attention
z
Since setting of the ID number on the remote
control can be performed even without the projector,
do not press the <ID SET> button carelessly. If the
number (<0> - <9>) button is not pressed within ve
seconds after the <ID SET> button is pressed, the
ID number returns to that before pressing the <ID
SET> button.
z
The ID number set on the remote control will
be stored unless it is set again. However, it will
be erased if the remote control is left with dead
batteries. Set the same ID number again when the
batteries are replaced.
Note
z
Set the ID number of the projector from the
[PROJECTOR SETUP] menu
[PROJECTOR ID]
(
page 61).
Connecting to the projector
with a cable
When you use the system with multiple projectors,
congure the units as in the following gure. Use a
commercial M3 stereo mini jack cable and connect
the other devices to the <REMOTE 1 IN>/<REMOTE
1 OUT> terminals of the projector.
It is effective to use the remote control in a place
where an obstacle stands in the light path or where
devices are susceptible to the outside light.
Connecting terminals
Connect to the
secondary projector
M3 stereo mini jack cable
(commercial)
Remote
control
Connect to the remote control
wired terminal
Attention
z
Use a cable that is 15 m or shorter, with 2 core
shield. The remote control may not operate when
the length of the cable exceeds 15 m or when the
shielding of the cable is inadequate.