Panasonic PT-DW730EL Projector Accessories User Manual


 
[PROJECTOR SETUP] menu
ENGLISH - 63
Settings
[LAMP RELAY]
The degradation of the lamp due to continuous usage
can be reduced by automatically switching the lamp
to be turned on when using the projector continuously
for 22 hours or more.
1) Press
▲▼
to select [LAMP RELAY].
2) Press ◀▶ to switch [LAMP RELAY].
z
The time setting to switch the lamp will change
as follows each time you press the button.
[OFF] [00:00]
(Every one
hour)
[23:00] [01:00]
Note
z
The LAMP RELAY function will be enabled when
[LAMP SELECT] is set to [DUAL] or [SINGLE].
z
Only one lamp is turned on for four hours after the
set time when [LAMP SELECT] is set to [DUAL].
z
The operating time will be the local time. (
page 65)
[LAMP POWER]
You can switch the brightness of the lamp in
accordance with the environment or purpose of usage
of the projector.
1) Press
▲▼
to select [LAMP POWER].
2) Press ◀▶ to switch [LAMP POWER].
z
The setting will change as follows each time
you press the button.
[HIGH] [LOW]
[HIGH]
Set when high luminance is
necessary.
[LOW]
Set when high luminance is not
necessary.
Note
z
When set to [LOW], the reduction of power
consumption, less operation sound, and longer life
of the lamp can be achieved.
[STANDBY MODE]
You can set the power consumption during the
standby.
1) Press
▲▼
to select [STANDBY MODE].
2) Press ◀▶ to switch [STANDBY
MODE].
z
The setting will change as follows each time
you press the button
[NORMAL] [ECO]
Note
z
When set to [ECO], the network function and the
<SERIAL OUT> terminal is not available during
the standby. Also, some of the RS-232C command
will not be available. When set to [NORMAL], the
network function and the <SERIAL OUT> terminal
will be available during the standby.
z
When set to [ECO], the time it takes to start the
projection may become approximately ten seconds
slower than compared to when set to [NORMAL].
[RS-232C]
You can set the communication condition of the
<SERIAL IN>/<SERIAL OUT> terminals.
1) Press
▲▼
to select [RS-232C].
2) Press the <ENTER> button.
3) Press
▲▼
to select the communication
condition.
4) Press ◀▶ to set it.
Note
z
Refer to
Serial terminal
(
page 98).