Panasonic PT-DW730EL Projector Accessories User Manual


 
[SECURITY] menu
ENGLISH - 71
Settings
Note
z
The logo is displayed on the whole screen in
the normal projection condition when [DEFAULT
LOGO] is set. Since the menu screen is displayed,
it is not possible to see the whole image even if the
logo display is canceled by pressing the <MENU>
button.
z
Separate software Logo Transfer Software is
required to create and register the pictures of [USER
LOGO]. Refer to the application software download
f
rom the website support information
(http://panasonic.net/avc/projector/software/).
[TEXT CHANGE]
You can change the text displayed when the text display
is enabled by selecting [TEXT] in [DISPLAY SETTING].
1) Press
▲▼
to select [TEXT CHANGE].
2) Press the <ENTER> button.
z
The [TEXT CHANGE] screen is displayed.
3) Press ▲▼◀▶ to select the text, and press
the <ENTER> button to enter the text.
z
Up to 22 characters can be entered.
4) Press
▲▼
◀▶ to select [OK] and
press the <ENTER> button.
z
The text is changed.
[MENU LOCK]
You can set to enable/disable the menu operation by
displaying the menu with the <MENU> button.
1) Press
▲▼
to select [MENU LOCK].
2) Press ◀▶ to switch [MENU LOCK].
z
The setting will change as follows each time
you press the button.
[OFF] [ON]
[OFF]
Releases the lock of the menu operation.
[ON] Locks the menu operation.
Note
z
The <MENU> button operations will be disabled
when an incorrect password is entered after setting
[MENU LOCK] to [ON].
z
The password setting is set to [OFF] at the time of
purchase or when [ALL USER DATA] is initialized.
z
The unlock status is maintained until the projector
is set to the standby mode.
[MENU LOCK PASSWORD]
You can change the MENU LOCK PASSWORD.
1) Press ▲▼ to select [MENU LOCK
PASSWORD].
2) Press the <ENTER> button.
z
The [MENU LOCK PASSWORD] screen is
displayed.
3) Press ▲▼◀▶ to select the text, and press
the <ENTER> button to enter the text.
z
Up to 16 characters can be entered.
4) Press
▲▼
◀▶ to select [OK] and
press the <ENTER> button.
z
Select [CANCEL] to stop.
Attention
z
The initial password when used for the rst time or
a
fter initializing all the user data is
AAAA
.
z
Change the password periodically that is hard to guess.
[CONTROL DEVICE SETUP]
You can enable/disable the button operations on the
control panel and the remote control.
1) Press
▲▼
to select [CONTROL
DEVICE SETUP].
2) Press the <ENTER> button.
z
The [CONTROL DEVICE SETUP] screen is
displayed.
3) Press
▲▼
to select [CONTROL PANEL]
or [REMOTE CONTROLLER].
4) Press the <ENTER> button.
z
The [CONTROL PANEL] or [REMOTE
CONTROLLER] screen is displayed.
[CONTROL PANEL]
z
You can set the limitation on the control from
the control panel.
[ENABLE]
Enables the button operation from
the main unit.
[DISABLE]
Disables the button operation from
the main unit.