Filter
Top Products
PROJECTOR SETUP menu
E
NGLISH - 41
Settings
PROJECTOR SETUP menu
Navigating through the MENU
(
Æ
page 29)
, select
PROJECTOR SETUP from the main menu and
then select the required item from the sub-menu.
Settheselecteditemwith◄►buttons.
z
Remote control Control panel
STATUS
You can check the using status of the projector.
SIGNAL
J
NAME: Name of input signal
z
FREQUENCY: Scanning frequency of input
z
signal
RUNTIME
J
PROJECTOR: Display current usage time of
z
projector
LAMP: Display current usage time of lamp
z
NO SIGNAL SHUT-OFF
If no image signal is input for the time set with the
timer, the projector will enter into standby mode
automatically.
Change setting
Change setting
DISABLE NO SIGNAL SHUT-OFF is disabled
15 - 60 MIN.
Timer can be set in intervals of 5
minutes
INITIAL START UP
You can set the starting method when the mains plug
is connected to mains socket.
Change setting
Change setting
LAST MEMORY
Projector starts from the last image
before the mains plug was
disconnected
STANDBY
Projector starts in the standby
mode
ON Projector starts immediately
INSTALLATION
When installing the projector, select the projection
method according to the projector position.
(
Æ
page 18)
Change setting
Change setting
FRONT/
DESK
Settingonadesk/oorand
projecting from front
FRONT/
CEILING
Mounting in the ceiling with a ceiling
mount bracket (sold separately) and
projecting from front
REAR/DESK
Settingonadesk/oorandprojecting
from rear (Translucent screen is
required)
REAR/CEILING
Mounting in the ceiling with a ceiling
mount bracket (sold separately) and
projecting from rear (Translucent
screen is required)
HIGH ALTITUDE MODE
If you use the projector at high elevation, the HIGH
ALTITUDE MODE setting need to be ON to set the
fan speed high.
Change setting
Change setting
OFF For use in normal environment
ON For use at high altitude
Remarks
At 1 400 -2 700 m (4 593 - 8 858 ft) sea level, the
z
setting must be ON.
The loudness of fan noise depends on the
z
HIGH
ALTITUDE MODE setting.