Filter
Top Products
PROJECTOR SETUP menu
42 -
E
NGLISH
Settings
STANDBY MODE
You can change the standby mode setting.
Change setting
Change setting
ECO
The standby power is reduced to
0.9 W to save power.
NORMAL
The power of the projector can be
turned ON and the audio output
can be set active from controlling
the computer connected via a
wired LAN or a wireless LAN in the
NORMAL mode.
LAMP POWER
You can adjust the power of the lamp to save electricity,
prolong the lamp life and reduce the noise.
Change setting Change setting
NORMAL When higher luminance is required
ECO Whenlowerluminanceissufcient
Remarks
When no input signal is detected, this function is
z
disabled.
The
z
ECO setting is recommended when higher
luminance is not required such as in a small room.
LAMP RUNTIME
You can check how long the lamp has been used.
Note
LAMP RUNTIME
z
is a relevant matter for lamp
replacement timing. See “Replacing the Lamp
unit”
(
Æ
page 50).
Check the lamp unit replacement time.
z
(
Æ
page 50)
Remarks
If the lamp runtime has reached 2 800 hours,
z
the red (time indicator) and grey marks appear
alternately to notify you of the lamp replacement
time.
The lamp life varies with its condition of use (number
z
of power-on times, etc. ).
EMULATE
When the projector is controlled with a computer
through serial input terminal, you can change the
setting to use the former projector control commands.
Press the ENTER button.1 )
Press▲▼buttons to select the required
2 )
setting.
Press the ENTER button.3 )
● DEFAULT
LB75 Series
LB78 Series
LB80 Series
LB90 Series
D3500 D3500
D4000 D4000
D/W5K series
D5500 Series
DW5000 Series
D5600 Series
DW5100 Series
D5700 Series
D/W/Z6K series
D5000 Series
D6000 Series
DW6300 Series
DZ6700 Series
DZ6710 Series
L730
L520 Series
L720 Series
L730 Series
L780
L750 Series
L780 Series
L735 L735 Series
L785 L785 Series
F/W series
F100 Series
FW100 Series
F200 Series
F300 Series
FW300 Series