Filter
Top Products
20
Connect (cont.)
“Glossary” (See page 61)
The newly registered connection is added to the
connection list in the window shown in step 1.
Click [ADD] and enter the IP address
(including its periods) of the
connection to be added, and then
click [REGISTER].
2
Click [Designate] at the
“Select Access Port”
window.
The window shown to the right appears.
1
When [Network] is set to [U] and the desired projector is not displayed at the “Select
Access port” window, connections can be added and deleted by the following
operations.
Adding a connection
When a projector with the [ ] mark is selected, the window
shown to the right appears. Enter the password and click [OK].
(See page 47)
Deleting a connection
Select the connection to be deleted at the window shown in step 1 and click
[DELETE].
Other operations for connection
• Click [CANCEL] at the password entry window to return to launcher (See page 23).
• When an incorrect password is entered, an error message appears. Click [OK] to
return to the password entry window and enter the correct password again.
Operations when password entry is required for connection
Adding and deleting connections