Filter
Top Products
21
Connect (cont.)
Even if there are two or more projectors with the same name, an ID ([Proj] + 4-digit
number) is assigned to each projector to enable the projectors to be identified. When
you click [ID Search], a search for the projector of the specified ID is carried out from
among the projectors that are presently switched on, from all channels other than [U].
It is necessary to know ID in advance. When input selection is switched to WIRELESS
on a projector, the ID appears on the upper right of the projection screen for
approximately 5 seconds. If you write down the ID displayed on the “Select Access
Port” window in advance, you can search a projector by the ID from next time.
Click [ ] on the launcher.
The “Select Access Port” window appears.
1
Enter four figures of desired projector’s ID, and click
[Search].
Start Searching.
3
When the projector of the applicable ID is found, the
computer will be connected to that projector, and the
status display of the launcher will turn green.
If appropriate ID is not found, an error message appears.
4
Click [ID Search].
[Projector ID Search] window appears.
2
Searching by projector’s ID