Filter
Top Products
4. AT Command Set and S-Registers
4-453830-A2-GB91-30 August 1998
Table 4-3
(16 of 20)
Model 3830 S-Registers
S77 DTR Alarm Reporting
Register determines whether an alarm is sent to the 6800 Series Network
Management System controller when the DTR signal has been Off for
more than 10 seconds.
Register has the following values:
0 = Disable
1 = Enable
S78 V.32bis Automode (Dial Line)
If enabled, automode permits the modem to automatically connect to a
remote modem using any supported modulation scheme.
If disabled, the modem only supports the modulation scheme selected by
the S41 register (Dial-Line Rate).
If the modem is in a modem pool attached to a System 85 Private Branch
Exchange (PBX), S78 should be set to 2. This modifies parameters used
during connection to the PBX.
Register has the following values:
0 = Enable
1 = Disable
2 = System 85
Factory setting is Enable.