Filter
Top Products
Monitoring and Troubleshooting
7-19
8700-A2-GB20-00
April 2000
Front Panel LEDs
The following table describes the meaning and states of the LEDs on the
faceplate. PORTS LEDs represent the DTE or DSL ports depending on the Port
LEDs selection on the Control screen.
Type
LED LED is . . .* Indicating . . .
SYSTEM
OK
(Green)
On
Off
Slow cycling
Pulsing
Normal operation; card functioning normally.
No power to card, or card failure.
Unit is in minimum mode and a download is
required.
Normal operation.
Alrm
(Amber)
On
Off
Device failure, Power-On Self-Test (POST) is
not complete, or an alarm was reported on a
DSL, DSX-1, or G.703 port.
No alarms.
Test
(Amber)
On
Slow cycling
Off
Loopback test or 511 test pattern in progress.
POST in progress.
No tests.
PORTS
(when
DSX-1 or
G.703
selected)
1, 2, 3, 4,
5, 6, 7, 8
(Green)
On
Slow cycling
Fast cycling
Off
Recoverable signal present on the DSX-1 or
G.703 network.
Yellow Alarm Indication (DSX-1) or Remote
Alarm Indication (G.703) present.
An OOF, LOF, EER, or AIS condition exists.
No signal on the port.
PORTS
(when DSL
selected)
1, 2, 3, 4,
5, 6, 7, 8
(Green)
On
Slow cycling
Fast cycling
Off
DSL link is up.
DSL training in progress.
OOF condition.
DSL link is down.
* Slow Cycling: LED turns off and on in equal duration once per second.
Fast Cycling: LED turns off and on in equal duration 5 times per second.
Pulsing: LED turns off momentarily once per second.
M/SDSL
8747
99-16606
SYSTEM
O
K
Alrm
Test
5
6
7
8
PORTS
1
2
3
4