Filter
Top Products
Troubleshooting
6-13
9664-A2-GB20-00
March 2000
Starting and Stopping a Test
Use this procedure to start, monitor, or abort specific tests. To abort all active
tests on all interfaces, see
Aborting All Tests
.
When the status of a test is . . .
The only command available is . . .
Inactive Start
Active Stop
Start or stop an individual test using the same procedure.
" Procedure
To start and stop a test:
1. Select the Test menu.
Main Menu
→
Test
2. Highlight the Start command for the test you want to start and press Enter.
Stop now appears and is highlighted, and the status of the test changes to
Active.
3. Press Enter to stop the test.
Start reappears and the status of the test changes back to Inactive.
4. View the length of time that the test has been running in the Result column.
Aborting All Tests
Use the Abort All Tests selection from the Test menu to abort all tests running on
all interfaces, with exception to DTE-initiated loopbacks. To abort individual tests
that are active, see
Starting and Stopping a Test
.
" Procedure
To abort all tests on all interfaces:
1. Select the Test menu.
Main Menu
→
Test
2. Select Abort All Tests and press Enter.
Command Complete appears when all tests on all interfaces have been
stopped.
NOTE:
Abort All Tests does not interrupt DTE-initiated loopbacks.