Filter
Top Products
User Interface and Basic Operation
2-2
9664-A2-GB20-00
March 2000
Logging On
Start a session using one of the following methods:
H Telnet session via:
— An in-band management channel through the frame relay network.
— A local in-band management channel configured on the DTE port
between the FrameSaver unit and the router.
H Direct terminal connection over the COM port.
When logging on, the User Interface Idle screen appears.
H If no security was set up or security was disabled, the Main Menu screen
appears (see page 2-4). You can begin your session.
H If security was set up and is enabled, you are prompted for a login. Enter
your login ID and password.
When the user interface has been idle, a session is automatically ended and the
screen goes blank when the unit times out. Press Enter to reactivate the
interface.
" Procedure
To log in when security is being enforced:
1. Type your assigned Login ID and press Enter.
2. Type your Password and press Enter.
— Valid characters – All printable ASCII characters
— Number of characters – Up to 10 characters can be entered in the
Login ID and Password fields
— Case-sensitive – Yes
An asterisk (*) appears in the password field for each character entered.
If your login was . . .
Then the . . .
Valid Main Menu appears (see page 2-4). Begin your session.
Invalid Message, Invalid Password, appears on line 24, and
the Login screen is redisplayed.
After three unsuccessful attempts:
– A Telnet session is closed.
– The User Interface Idle screen appears for a directly
connected terminal.
– An SNMP trap is generated.
Access is denied.
See your system administrator to verify your login (Login
ID/Password combination).