Filter
Top Products
9
1088/C ignores DTE loop requests. In the Off position, loop requests
may still be initiated by the front panel switch.
Configuration Switch Set “S3”
Use the six DIP Switches in Switch S3 to enable the DTE bit rate. The
following table summarizes default positions of DIP Switch S3. Detailed
descriptions of each switch follow the table.
Table 2:
S3 Summary Table
Switch S3-1: DTE Rate.
Use Switch S3-1 through S3-6 to set the DTE
bit rate.
S2-8 Setting
On DTE Loopback Request Enabled
Off DTE Loopback Request Disabled
S3-1 S3-2 S3-3 S3-4 S3-5 S3-6 DTE Rate (kbps)
Off Off On On On On 64
On On Off On On On 128
Off On Off On On On 192
On Off Off On On On 256
Off Off Off On On On 320
On On On Off On On 384
Off On On Off On On 448
On Off On Off On On 512
Off Off On Off On On 576
On On Off Off On On 640
Off On Off Off On On 704
S3 SUMMARY TABLE
Position Function Factory Default
S3-1 DTE Rate On
S3-2 DTE Rate Off
S3-3 DTE Rate Off
S3-4 DTE Rate Off
S3-5 DTE Rate On
S3-6 DTE Rate On
S3-7 Reset Software Defaults On
Normal Operation
S3-8
Transmit Data Sample Point
On Normal Operation
768 kbps