Filter
Top Products
Introduction 38
Model 3088 Series User Manual 2 • Configuration
t1e1 set lbo <75ohm|120ohm|0.0|7.5|15.0|22.5>
Select the line build out. 75? and 120? can only be use for E1 line types. The others can only be used for T1
line types.
t1e1 set timeslots <1-32>
Specify the number of T1/E1 timeslots to map to DSL timeslots. E1 has a maximum of 32 timeslots and T1
has a maximum of 24 timeslots.
t1e1 set tsmap <tsmap>
Specify the T1/E1 timeslots to map to DSL timeslots. This is a string that can contain ranges (-) and groups (,).
For example, the string 2-4,8-9 will select timeslots 2, 3, 4, 8, and 9.
t1e1 set rxeq <enabled|disabled>
Enable or disable the Rx equalizer. This is usually only enabled for long haul applications.
t1e1 set passframing <enabled|disabled>
Specify whether or not to pass the f-bit transparently in T1 modes. This must be enabled for T1-
Unframed mode.
t1e1 set passalarms <enabled|disabled>
Specify whether to generate alarms on the remote unit when detected on the local unit.
T1/E1 Status Commands
t1e1 show status: Shows the active T1/E1 configuration, loss-of-signal and framing errors, alarms, and perfor-
mance statistics.
Remote Console
Provided that there is a DSL link to a second 3088, a user may login to the first 3088’s console and enter the
remote console command to access the second 3088’s console. Using this remote console feature, the user can
configure and query the status of the second 3088 from a remote location. When the user is finished with the
remote console, the logout command can be used to return to the local console.
Example Command Line Interface Session
password: ******
> system set circuitid “3088 Circuit ID”
> system set timeslots 3
> system set clockmode internal
> dsl set annex b
> dsl set lineprobe disabled
> system save config
> dsl start
> system show status
leds: power: on dsl: on tm/er: off
dsl test mode:
ber status: idle
errors: 0
time: 0
front panel switches: sw1: normal sw2: normal
dsl link state: success
configuration mode: software
> dsl show status
link state: success
sync state: in sync
link speed: 192k
error counters:
crc: 0
losw: 0