Filter
Top Products
753 Printer sensed a mark that is too long.
756 The printer is out of supplies. Load supplies.
757 Load supplies. The calibrated supply length differs by
plus or minus .25 inches from the format.
758 Check supply. Either the supply is not seen, or the
on-demand sensor is broken (purchase optional).
Check for a label jam. Clear the supply path or reload
supplies. This error may occur if you remove a label
too quickly in on-demand mode. The printer does not
recalibrate after this error.
762 Low battery. Recharge the battery.
763
Waiting to dispense label. Press the F button.
768 Printhead has more than 10 bad dots or is not
connected. Make sure the printhead is connected.
790 The printer is busy. Turn off the printer. Wait two
seconds and turn it back on. Resend the packets. If
the problem continues, call Technical Support.
791 The printer has an error pending. Turn off the printer.
Wait two seconds and turn it back on. Resend the
packets. If the problem continues, call Technical
Support.
Troubleshooting
8-17