Filter
Top Products
Common Errors
Error Description
025 String length is outside the range 0 to 2710.
101 The format referenced by batch is not in memory.
409 The printer memory is full. Delete unnecessary formats or
graphics from memory.
410 Parity mismatch.
411 Framing error (baud rate mismatch).
412 Flow control mismatch.
413 Online receive queue is full. Check for a flow control problem.
611 Font, bar code, or density in the batch does not fit the format.
612 The data in this line of the batch is either missing or does not
match the format.
613 Reference point off supply.
614 Portion of field off supply or there may be an invalid character
in the packet.
703 The printer sensed a calibration of different-sized black marks.
Make sure the correct supply is loaded. The 9805 printer
does not support black mark supply.
704 Printer has not sensed a supply mark within the specified
number of inches or is out of supplies. Check the supply
tracking, supply marks, black mark sensor position, and
supply roll for binding. Change supply. Press Clear.
750 Printhead is overheated. Turn off the printer.
751 Printer did not sense a black mark when expected. For errors
751-753, Check the supply tracking, supply marks, black mark
sensor position, and supply roll for binding. Press Clear and
try to continue printing. Change supply. The 9805 printer
does not support black mark supply.
752 Printer sensed a mark in the wrong place. The 9805 printer
does not support black mark supply.
753 Printer sensed a mark that is too long. The 9805 printer does
not support black mark supply.
754 Check for a ribbon jam or remove any slack by turning the
take-up reel clockwise.
755 Printhead is open. Close the printhead before continuing.
756 Load supplies.
757 Load supplies (supply length mismatch), because the
calibrated supply length differs by plus or minus .25 inches
from the format. Press Feed.
13