Filter
Top Products
3. Feed the backing paper over
the peel bar.
4. Feed the backing paper through
the lower opening of the exit
cover. Close the exit cover.
Pull down on the backing paper
to remove any slack.
When removing the backing
paper, pull up across the
saw-toothed tear edge. Make
sure the backing paper tears at the
edge.
5. Close the printer’s cover.
6. Press Feed to position the
supply under the printhead.
Adjusting the Wide/Narrow Knobs
You may need to adjust the two
wide/narrow knobs according to the
width of your supply. For supply that is
more than two inches wide, adjust the
knobs to the wide setting. For supply
that is two inches wide or less, adjust
the knobs to the narrow setting. Adjust
both of the knobs to the same position.
For wide supplies, push down and turn
the wide/narrow knobs clockwise with a
screwdriver. For narrow supplies, turn
the wide/narrow knobs counter-clockwise with a screwdriver until it pops
back up. The adjustment is shown in the wide position.
If you experience supply feeding problems with 2.0-inch wide or less
supplies, adjust the wide/narrow knobs to the wide setting. You may also
need to use the wide setting in cold, dry environments.
Tear Edge
Peel Bar
Lower
Opening
5