Filter
Top Products
32 Pelco Manual C1921M-G (1/04)
Exits main tracking mode.1. Go to the Advanced System Setup menu.
2. Move the joystick so the cursor highlights SPOT MONITOR
DISPLAY items.
3. Press the OPEN key until SEQUENCE or BLANK is
displayed.
4. Exit the Advanced System Setup menu.
1. Press the MAIN MONITOR key. The green LED over the
MAIN key lights.
2. On the number pad, press the multiplexer’s address number
(1-16 if the keyboard is connected to a multiplexer; 1-8 if
connected to a server), and then press the UNIT key. The
LED displays the address.
3. Press the key below the 4, 9, or 16 icon.
4. Repeatedly press the key until the correct group is displayed
(4 or 9 only).
5. Press the LIVE/VCR key to select the operating mode.
1. Press the MAIN MONITOR key. The green LED over the
MAIN key lights.
2. Select the camera you want displayed full size.
Addressing by Multiplexer (Switch 7 OFF)
a. On the number pad, press the multiplexer’s address
number (1-16 if the keyboard is connected to the
multiplexer; 1-8 if connected to a server), and then
press the UNIT key. The LED displays the address.
b. On the number pad, press the camera number (1-16),
and then press the CAM key.
Addressing Consecutively (Switch 7 ON)
On the number pad, press the camera number, and then
press the CAM key. Refer to Table A for camera numbers.
3. Ensure the main monitor displays live video. If not live, press
the LIVE/VCR key.
4. Press the PIP icon key.
5. On the number pad, press the number of the camera you
want to display in the insert. Then press the CAM key. (Note:
Both cameras must be connected to the same multiplexer.)
6. To change the insert display, press the number of the
camera, and then press the CAM key.
7. To exit, press the PIP icon key.
Exit main tracking.
Table E. Operation Guide (Continued)
OPERATION KEYBOARD COMMAND RESULT
(Continued on next page)
Displays the group of
cameras on the main monitor.
Call a group of
cameras to the
main monitor.
Display a picture-in-
picture (PIP) insert
on the main
monitor.
The full-size view appears on
the main monitor with PIP
insert.
NOTE: You must exit PIP
mode to change the camera
shown in full-screen view.