Filter
Top Products
GW-200 User Manual
38
X-0: Connect to FTP Server to get the file of updating program and
save it to the SDRAM of the gateway. Then the file can be read by
PalmTool. This operation aims at testing.
X-1: Connect to FTP Server to get the file of updating program and
update program Flash. This operation aims at updating program.
X-2: Connect to FTP Server to get the file of updating dial rules and
update program Flash. This operation aims at updating dial rule.
Note When you use ftp 0 and ftp 1 commands, if the file get from FTP server
is too large or the net speed is too slow, then the process will not be
seen in telnet window. Please be patient. Using ftp command in telnet
to get file spends almost same minutes as getting file using gateway.
So if nothing is displayed after too long time, it means that ftp is fail.
Note
All the Telnet commands of GW-200 gateway should be written in low
case and the password is case sensitive.
Usage of the phone
Receiving calls:
GW-200 gateway can receive incoming calls from other IP Phone or
another IP Gateway which and support the protocol. It works just like an
ordinary phone. When it rings, pick up the handset to answer the incoming
calls and finish, put the handset back.
Place a call
Call another IP Gateway or IP phone under the same Gatekeeper:
Pick up the handset and listen for the Internet dial tone. Then dial the
phone number you wish to call and press [#] to end the dialing. Once the
call connection has been established and the ring tone has sounded, wait