Filter
Top Products
GW-200 User Manual
9
mask and router IP address of gateway manually.
dhcp
: Select this item to enable DHCP mode. With this system, your
LAN or router automatically assigns all the required network parameters
to any device connected to it when the device log on. GW-200 Gateway
is shipped from the factory with DHCP on. So, if you’re LAN or router is
configured to use DHCP addressing, the gateway’s LAN parameters will
automatically be configured as soon as it is connected to the LAN or
router and powered up.
pppoe
Those ADSL and Cable Modem users please select this item for
it is a protocol especially designed for them. With this system, ADSL ISP
automatically assigns all the required IP parameters to any device
connected to it when the device log on.
modem
If the gateway used with modem, please select this item to get
relevant network parameters auto. Then please fill ID and pin into ppp id
and ppppin fields.
ppp id:
With
pppoe
or
modem
selected in
iptype
drop down list, please
enter the user name here.
ppp pin:
With
pppoe
or
modem
selected in
iptype
drop down list,
please enter the password here.