Filter
Top Products
DM1000™ Digital Mailing System Operating Guide
SV60951 Rev. B 6-5
Connecting
Your
Po
stage
Meter to an
Analog
Phone Line
Which connector do I use?
Internal Analog Phone Line Connector - Use the internal analog modem
to connect directly to an analog phone line.
If your mailing system is not located near an analog phone line and you
ne
ed to remove the control center when you perform feature updates or
add postage, refer to Connecting Your Postage Meter to a Remote Analog
Line in this section.
Connecting Your
Mailing System
to a Remote
Analog Phone
Line
If you need to connect to an analog phone line that is not located near your
mailing system, you can remove the IntelliLink® Control Center and move it
to a location near the analog phone line. At the remote location, plug one
end of the AC Adapter (P/N 1C85005) into the back of the control center
and the other end into an AC outlet.
To remove the control center and move it to another location:
1. Turn off the power to the mailing system.
2. Pull the blue lever at the right of
the
control center towards you.
3. Slide the control center forward
to r
emove it.
4. Take the control center to
where the
analog phone line is.
5. Connect the telephone cord
(A
WG 26) from the internal
analog connector to the analog
telephone line.
6. Connect the A/C Adapter (P/N
1C850
05) to the back of the
control center and plug it into
an AC outlet.
2
Internal Analog Phone
Line Connector
Use this to connect
directly to an analog
phone line
IntelliLink® Control Center installed on a DM1000™ Digital Mailing System base.
Dotted line indicates AC Adapter Receptacle is covered by base
Pull the blue lever forward to
release the control center