Filter
Top Products
DM1000™ Digital Mailing System Operating Guide
SV60951 Rev. B 4-33
Adding
Postage or
Changing
th
e Date
If you do not have the correct postage or date on a piece of mail, you can
add more postage or change the date directly on a piece of mail. If you pre-
fer, you can print the corrections on at a tape instead and then apply it to
the
piece of mail.
Adding More Postage
1. If you are printing more postage on an envelope and if the envelope is
sealed, press the seal key and select Sealer Off. If you are printing on
a tape, go to step 3.
2. Turn the piece of mail around 180 degrees so that the meter stamp is in
the
lower left corner as shown here. Then, place the envelope on the
feed deck with the flap facing down.
3. To add more postage, press the Mode ke
y and select Key In Postage.
4. Enter the additional amount using the numeric keys and press En
ter.
Press the Start key. If you are printing a tape, press the Tape key. The
additional postage prints on the envelope as shown below.
5. If y
ou print a tape, apply the tape to the envelope below the existing
meter stamp.
8
00 30
00 30
00 30
00 07
00 30