Filter
Top Products
6-13
Problems?
6 Blinks—Circulation valve home position sensor
Call the National Service Centre. See page 6-1.
7 Blinks—Carriage home position sensor
Call the National Service Centre. See page 6-1.
8 Blinks—Home position error
Call the National Service Centre. See page 6-1.
9 Blinks—Fan error
Call the National Service Centre. See page 6-1.
10 Blinks—Serial communications error
You may need to replace the print head. Call the National Service Centre. See
page 6-1.
11 Blinks—Print head not installed
Problems with the print head. If this error continues, call the National Service
Centre. See page 6-1.
12 Blinks—Ink sensor error
Call the National Service Centre. See page 6-1.
13 Blinks—Jam in stand-alone mode
Remove envelope and restart machine.
14 Blinks—Skew in stand-alone mode
Remove envelope; then reset meter by turning meter release lever to the Remove
position, waiting a moment or two, then turning it back to Operate .
15 Blinks—EEPROM failure
Call the National Service Centre. See page 6-1.
16 Blinks—Motor Drive IC error
Call the National Service Centre. See page 6-1.
17 Blinks—Meter serial communication error
Make sure the Postage Meter is installed properly onto the Mailing Machine.
Restart machine. If error recurs, call the National Service Centre. See page 6-1.
18 Blinks—Print head drive voltage error
Call the National Service Centre. See page 6-1.