Filter
Top Products
Operation
Planar PD7170 Installation/Operation Manual 35
PREL
I
MINA
R
Y
4.1
Selecting Video Memory
Press M1, M2 or M3 to recall settings from a memory preset. Then, press ENTER to
confirm your selection. Or, to cancel the operation, press
to select Cancel
and press ENTER.
You can assign each of these three buttons to any
of four memory presets. For more information, refer
to
M1 Key / M2 Key / M3 Key on page 59.
4.2
Selecting an Aspect
Ratio
Press the aspect ratio ( ) button to select the appropriate aspect ratio for the
type of program material being viewed. For more information, refer to Table 4-2.
4.3
Selecting An Input
Source
When you turn on the PD7170, it switches to the last
selected input and looks for a valid signal.
Use these buttons on the remote control to select
an input source directly. You can assign each of
these five buttons to any input. The default
assignments are: 1 = HDMI 1, 2 = HDMI 2,
3
= Component 1, 4 = S-Video, 5 = Video.
For more information, refer to 1 Key / 2 Key / 3 Key / 4 Key / 5 Key on page 59.
4. Operation
M1 M2 M3
SHARP
USER MEMORY
1
4
2 3
5
▲
SOURCE