Filter
Top Products
Telephony Interface Port Configuration Commands
19
4. Telephony Interface Port Configuration Commands
Each telephony interface port equipped by the ITG, regardless of its interface type,
is characterized by two sets of configuration parameters. One set is unique to each
port, hereafter referred to as port-unique parameters. The other set is common to all
the telephony interface ports, hereafter referred to as port-common parameters. The
ITG maintains two sets of port-common parameters, primary and secondary. One of the
port-unique parameters is used to select which of the port-common parameters the port
will use.
This chapter describes commands for configuring the port-unique and port-common
configuration parameters.
This chapter is organized as follows:
l Port-Unique configuration commands
l Port-Common configuration commands
Configuring Port-Unique Parameters
The following sections describe commands for configuring port-unique parameters.
set port port# cid name
This command is used to set the Caller ID Name for a telephony port.
set port port# cid name {name | O}
Syntax description
port# Zero-based number of the telephony port.
name Caller ID name, 1 to 10 characters. Use hyphen (‘-
‘) to represent
spaces in the name.
O Caller ID is name is not available
Factory default
No caller ID name
set port port# cid number
This command is used to set the Caller ID Number for a telephony port.
set port port# cid number {number | O}
Syntax description