Filter
Top Products
H.323 Configuration Commands
40
off Disable the feature.
Factory default
on
set h323 out_fast_start
This command is used to select the H.323 mode for outgoing calls.
set h323 out_fast_start {on | off}
Syntax Description
on Initiate outgoing calls with H323 Fast Start mode
off Initiate outgoing calls with H323 Non Fast Start mode
Factory default
off
Related Command
set h323 in_fast_start
set h323 rtp_port_base
This command is used to select the starting port number for assignment of RTP ports. When
calls are made to remote gateways, an RTP and RTCP ports are opened for each call. The ITG
uses the port_base as the RTP port number and port_base + 1 as the RTCP port for the first
call, the next call uses the next two successive ports, and so on.
set h323 rtp_port_base port_base
Syntax Description
port_base The starting port number for the assignment of RTP port. If
port_base is assigned a value of 0,
the assignment of port number
will be dynamic. The port number can be specified from 0 to
32767, and per H.323 Standard, it must be an even number.
Typically, numbers from 0 to 1023 are reserved on most systems.
The recommended value is 30000.
Factory default
30000
set h323 term_id
One of the UUIEs in the H.323 Setup message that the ITG sends to a remote gateway when
initiating a call is sourceAddress. The sourceAddress UUIE is a list of alias addresses, by which
the remote gateway identifies the ITG. This command is used to set a string that the ITG will
place in the 1
st
alias address filed of the sourceAddress UUIE in the H.323 Setup message.
This string is also placed in the 1
st
alias address filed in the terminalAlias filed in RRQ the
gateways sends to the gatekeeper for registration.
set h323 term_id string
Syntax Description
string The string, up to 64 characters, to be is encapsulated the 1
st
alias
address field of
sourceAddress
UUIE of the H.323 Setup message