Filter
Top Products
Telephony Interface Port Configuration Commands
21
show port port#
This command displays port-unique parameters for a telephony interface port.
show port
Syntax Description
port# Zero-based number of the telephony port.
Configuring Port-Common Parameters
The ITG maintains two sets of port-common parameters, primary and secondary. Each
telephony port chooses which of them to be used by specifying it in one of its port-unique
parameters. Refer to command “set port port# port_cfg” on page 20 for details on how to
choose port-common parameters for a telephony port.
The following sections describe commands for configuring port-common parameters.
Commands for configuring port-common parameters share the same syntax as follows:
set port_cfg [sec] option [option] . . .
Where the optional key word sec, if entered, stands for configuring secondary port-common
parameter. This key word may be omitted, if you are configuring the primary port-common
configuration. For simplicity, commands described in the following sections only include those
for configuring primary port-common parameters.
Commands for configuring port-common parameters are categorized into the following
groups:
Ÿ Commands for configuring general port-common parameters that apply to all types of
telephony interface port.
Ÿ
Commands for configuring port-common parameters unique to FXO interface
Ÿ
Commands for configuring port-common parameters unique to FXS interface
Configuration General Port-Common Parameters
The following sections describe commands that apply to all types of telephony interface port.
set port_cfg ans_wait
This command is used to set a wait-for-answer time limit on a telephony port. If the call
destination does not answer within this period, the call is automatically terminated.
set port_cfg anw_wait seconds
Syntax description
seconds Value in seconds, ranging from 0 to 65534, or –
1 or 65535 for
forever.
Factory default
-1