Filter
Top Products
Connecting composite video
You can display composite video (NTSC, PAL or SECAM) on
the projector.
Use the supplied AV cable to connect an NTSC, PAL, or
SECAM source to your projector.
1 Find the RCA connector on your video source marked
VIDEO OUT or something similar. This connector is usually
yellow. Insert one of the yellow AV-cable connectors into
the VIDEO OUT jack of the video source.
2 Insert the other yellow connector into the projector VIDEO 1
p o r t .
Connecting an S-Video source
To connect an S-Video source, use the supplied S-Video
cable instead of an RCA cable connection. The S-Video
cable has identical, round, 4-pin mini-DIN connectors on
both ends.
To connect an S-Video source:
1 Insert one end of the S-Video cable into the mini-DIN VIDEO
OUT port of the video source.
2 Insert the other end of the S-Video cable into the projector
S-VIDEO port.
3 Use the red and white AV-cable connectors to connect
audio from the S-Video source to the projector. See the fol-
lowing section, Connecting non-computer audio.
Detailed setup 21