Filter
Top Products
5 Grasp the lamp assembly and firmly pull it straight out of
the projector, as shown below.
Removing the lamp
assembly
6 Replace the old lamp assembly with a new one, carefully
aligning the power pins on the bottom, and pressing it firm-
ly into place. When the assembly is properly installed, a
small alignment mark etched on the projector chassis is visi-
ble below the lamp assembly.
7 Tighten the 4 lamp-assembly screws.
8 Replace the service door and screw it into place.
9 Plug the power cord back into the projector and the wall
o u t l e t .
Maintenance 47