Filter
Top Products
Polycom RMX 1500/2000/4000 Getting Started Guide
2-5
Unpacking the RMX
Unpacking the RMX 1500
To unpack and lift the RMX 1500:
1 When you receive the RMX 1500 packing case, inspect the equipment
for damage and verify that the components match the packing slip.
2 Open the top cover of the packing case.
Two boxes are placed on the top Stratocell®, labelled:
— Installation Accessories. This kit contains the power cables and a
Disk-on Key (DOK).
— Rack Installation Accessories. This kit contains the accessories for
the 19”/23” racks as follows:
Unpacking the RMX 2000
To unpack and lift the RMX 2000:
1 When you receive the RMX 2000 packing case, inspect the equipment
for damage and verify that the components match the packing slip.
2 Open the top cover of the RMX 2000 packing case and make sure that
the Installation Accessories kit contains the power cables and a USB
Key.
3 Remove the top cover, lift the RMX 2000 from the package and place
it on a flat surface.
Write down the RMX’s serial number that is on a sticker on the back of the unit.
It will be needed for product registration later in the process.
Table 2-2 19” & 23” Rack Installation Accessories Package
Item ID Description Quantity
MEC2791A-L0 Chassis runner (60cm in length) for
rack installation on the RMX 1500.
19”/23” racks both require that these
runners be installed on the rack.
2
Write down the RMX’s serial number that is on a sticker on the back of the unit.
It will be needed for product registration later in the process.