Filter
Top Products
10 Supplies and Driver Settings
Installing Label Stock
The following steps will guide you through loading label stock
in your printer:
Make sure power is connected and printer is on.
1. Open the Top Cover.
2. Lower the Roll Guide and pull it outward to make room
for your label stock.
3. Pull the Movable Throat Guide outward to make room for
the label stock.
4. Remove any shipping tape from your label stock roll to
ensure that it can unroll freely, making certain that no
adhesive portion is exposed. It is important to note that
any exposed adhesive surface can attach itself the the inner
workings of the print mechanism and cause a media jam.
5. Place your roll of label stock on the Roll Arm and push it
inward until it touches the stop.
6. Flip up the Roll Guide and slide it inward until it touches
the label stock. (The Roll Guide will automatically pull
back slightly to the correct position)
2. Lower the Roll Guide
and Pull it Outward.
1. Open Cover.
3. Pull Throat Guide Out.
510910.qxd 9/26/2005 2:32 PM Page 10
TOC
INDEX