Filter
Top Products
Supplies and Driver Settings 21
TOF Offset
TOF stands for Top of Form and this setting allows you to fine
tune the alignment of your printing on your label stock. This
will be factory calibrated. If fine tuning is needed, increase this
setting to move the image down on the label. The unit of
measure is 0.1mm.
Tear Off Offset
If Rewinder Mode (described earlier in this section) is set to No,
the printer will present your labels over the Tear Bar for easy
removal. This is set at the factory. If fine tuning is needed to
align the break in your label stock over the Tear Bar, increase
this setting to eject the label further; decrease this setting to
eject the label stock less. The unit of measure is 0.1 mm.
510910.qxd 9/26/2005 2:32 PM Page 21
TOC
INDEX