Filter
Top Products
Chapter 4 System Setup 35
35
Connecting the Interface (Controller-Computer) Cable
TAXI
®
Cable (6050-0148-CE)
Turn the Controller power OFF (OFF = 0, ON = |) and the Computer power OFF before
connecting or disconnecting the Controller-Computer (TAXI) cable.
To Connect the TAXI Cable:
1. Verify that the Controller power is OFF.
2. Verify that the Computer power is OFF.
3. Connect one end of the TAXI
cable to the 9-pin port on the Interface card in the
host computer.
4. Tighten down the screws to lock the connector in place.
5. Connect the other end of the cable to the "Serial Com" port on the rear of the
Controller.
6. Tighten down the screws to lock the connector in place.
USB 2.0 Cable (6050-0494)
Turn the Controller power OFF (OFF = 0, ON = |) and the Computer power OFF before
connecting or disconnecting the Controller-Computer (TAXI) cable.
To Connect the USB 2.0 Cable:
1. Verify that the Controller power is OFF.
2. Verify that the Computer power is OFF.
3. Connect one end of the USB cable to the USB port on the host computer.
4. Connect the other end of the cable to the USB 2.0 port on the rear of the
Controller.
Connecting the Camera-Controller Cable
Turn the Controller power OFF (OFF = 0, ON = |) before connecting or disconnecting the
Camera-Controller cable.
To Connect the Camera-Controller Cable (6050-0484):
1. Verify that the Controller power is OFF.
2. Connect male end of the Camera-Controller cable to the "Detector" port on the
back of the Controller.
3. Move the slide latch over to lock the connector in place.
4. Connect the female end of the cable to the Camera.
5. Move the slide latch over to lock the connector in place.
Caution
Caution
Caution