Filter
Top Products
DAILY OPERATION
27
Ejecting and Tearing Off a Form
When most print jobs are complete, the printer will command the paper to
be positioned at the top of the next form so that the printer is ready for the
next job. This is, however, dependent solely upon how the programmer
chose to write your particular application software. If your software does
position the paper at the top of the next form, the printer will automatically
position the form at the tear bar as shown in the following picture.
Bottom of form at tear bar
If your form is positioned as shown, you may skip the next section on
positioning and proceed with “Tearing off a Form”.
Positioning the Form for Tear Off
1. If your print job has completed and the form is not positioned as
shown above, take the printer off line by pressing the ONLINE button
(indicator will change from green to flashing red).