Filter
Top Products
DAILY OPERATION
32
If the error is caused by a paper jam, remove the jammed form. If the form
remaining in the tractors has tears along the top edge, remove it from the
tractors, tear it off, and place the next form in the tractors.
If the error is caused by running out of paper, simply load a form as
previously described.
Finally, place the printer back on line by pressing the ONLINE button. This
will automatically load the new form and begin printing. Depending upon
how the printer has been set up, the printer may start printing where it left
off or it may start at the beginning of the page where the error occurred and
reprint the entire page. See “Paper Out Fault Action” on page 54 for more
information.
No Paper to Load
This error occurs when the LOAD/FEED button has been pressed and there
is no paper or form in the tractors. Place paper in the tractors and press
LOAD/FEED again.
Too Much Paper to Unload
This error occurs when the UNLOAD/CHANGE button has been pressed and
there is paper present too far beyond the tear bar. This error serves as a
warning that you may be putting forms that have already been printed on
back into the printer. Tear off any printed forms past the tear bar and press
UNLOAD/CHANGE again. This error also occurs if the LOAD/FEED button
has been pressed and the current form cannot be unloaded.
Selected Form is not Loaded
This error occurs when ONLINE has been pressed and the currently selected
form is displaying <Not Loaded>. Either press LOAD/FEED to load
the selected form or select a different form, then press LOAD/FEED and then
press ONLINE.