Filter
Top Products
42
Chapter 3 Configuring The KSSM Emulation With Control Codes
Divided Hangul Double Height
ASCII Code FS X
n
Hex Code 28 58
n
Dec Code 1C 88
n
Purpose Turns on/off divided double height printing of all characters as
follows:
n
= 0 Turns off divided double height
n
= 1 Double height upper part of character
n
= 2 Double height lower part of character
n
= 3 Double height whole character
Where:
0 <=
n
<= 3
Comment The line spacing of the line with upper part double height (set
by FS X 1) will change to 24/180 inch.
The baseline of the line including double-height characters (set
by FS X 3) moves down 24/180 inch, and the line spacing also
increases 24/180 inch.
The default is Normal (non double-width double-height)
printing.
Enable Printing of Upper Control Codes
ASCII Code ESC 6
Hex Code 1B 36
Dec Code 27 54
Purpose Tells the printer to treat codes 128 to 159 as printable
characters instead of control codes.
Comment This command affects the front panel setting of “Alt. Set 80-9F.”
This command works in ASCII mode only.
In the default mode, codes 128 to 159 are treated as printable
characters.