Printronix PSA3 Printer User Manual


 
80
Chapter 3 Configuring The KSSM Emulation With Control Codes
Turn Underline On/Off (Hangul Extension)
ASCII Code FS -
n
Hex Code 1C 2D
n
Dec Code 28 45
n
Purpose Turns on/off printing of a line below all characters and spaces
following the command:
n
= 0 or 48Turns underline off
n
= 1 or 49Prints one dot underline
n
= 2 or 50Prints two dot underline
Where:
n
= 0, 1, 48, 49
Comment If the character is in vertical printing mode, the line prints over
the character and becomes overscored.
Underline and overscore each increase 4/180 inch line spacing.
The default is Normal (non-underlined) style.