Filter
Top Products
78
Chapter 3 Configuring The KSSM Emulation With Control Codes
Turn Extending Table Character On/Off
ASCII Code FS v
n
Hex Code 1C 76
n
Dec Code 28 118
n
Purpose Turns on/off extending table characters, as follows:
n
= 0 or 48Cancels extending table characters
n
= 1 or 49Selects extending table characters
Where:
n
= 0, 1, 48, 49
Comment This command extends the table characters so they touch in
both horizontal and vertical directions.
The limitation of extension is ½ inch.
Our printer could extend the table characters in the range of
A6A1H to A6E4H in the Hangul Complete font.
The default is Table Character not extended.
Turn On/Off OCRB Selection
ASCII Code ASSC 0 z
n
Hex Code ASSC 30 7A
n
Dec Code ASSC 48 122
n
Purpose Turns on/off OCRB selection as follows:
n
= 0 or 48Turns off OCRB selection
n
= 1 or 49Turns on OCRB selection
Where:
n
= 0, 1, 48, 49
Comment When OCRB selection is turned on, the OCRB character can
be printed out.
This command affects the front panel setting of “OCRB
Selection.”
This command works only in DBCS mode.
The default is
n
= 0.