Filter
Top Products
50
Chapter 3 Configuring The KSSM Emulation With Control Codes
Reassign Bit-image Mode
ASCII Code ESC ?
n m
Hex Code 1B 3F
n m
Dec Code 27 63
n m
Purpose Assigns the dot density used during the ESC K, ESC L, ESC Y,
or ESC Z commands to the density specified by parameter
m
in
the ESC * command.
Where:
n
= 75, 76, 89, 90
0 <=
m
<= 40
Comment The default settings are as follows:
ESC K is assigned density 0
ESC L is assigned density 1
ESC Y is assigned density 2
ESC Z is assigned density 3
Select 1/6-inch Line Spacing
ASCII Code ESC 2
Hex Code 1B 32
Dec Code 27 50
Purpose Sets the line spacing to 1/6 inch.
Comment Changing the line spacing does not affect previous settings for
vertical tabs or page length.
This command affects the front panel setting of “Select LPI.”
Select 1/8-inch Line Spacing
ASCII Code ESC 0
Hex Code 1B 30
Dec Code 27 48
Purpose Sets the line spacing to 1/8 inch.
Comment Changing the line spacing does not affect previous settings for
vertical tabs or page length.
This command affects the front panel setting of “Select LPI.”