Filter
Top Products
Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
199
Other Parameters
IAPP Parameters
NOTE: These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.
Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters
The Wireless Multimedia Enhancements commands enable and configure Wireless Multimedia Enhancement/Quality of
Service parameters. The following two commands are part of the Wireless Interface Properties table.
Enabling QoS
Configuring QoS Policies
The QoS group manages the QoS policies:
Name Type Value Access CLI Parameter
IAPP Group N/A R iapp
IAPP Status Integer enable (default)
disable
RW iappstatus
Periodic Announce
Interval (seconds)
Integer 80
120 (default)
160
200
RW iappannint
Announce Response
Time
Integer 2 seconds R iappannresp
Handover Time-out Integer 410 ms
512 ms (default)
614 ms
717 ms
819 ms
RW iapphandtout
Max. Handover
Retransmissions
Integer 1 - 4 (default 4) RW iapphandretx
Send Announce Request
on Startup
Integer enable (default)
disable
RW iappannreqstart
Name Type Value Access CLI Parameter
QoS Status Object Status enable
disable (default)
RW qosstatus
QoS Maximum Medium
Threshold
Integer 50 - 90 RW qosmaximummediumthresh
old
Name Type Value Access CLI Parameter
QoS Group Group N/A N/A qos
QoS Policy Table Table N/A N/A qospolicytbl
Table Primary Index Integer N/A R index
Table Secondary Index Integer N/A R secindex
Policy Name Display String 0 - 32 characters RW policyname