Filter
Top Products
Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
200
* QoS must be enabled on the wireless interface before spectralink can be enabled.
† A priority mapping needs to be specified for a QoS Policy. The priority mapping depends on the type of policy configured. For Layer 2 policy
types (inbound or outbound) a mapping index from the 802.1p to 802.1D table should be specified. For Layer 3 policy types (inbound or out-
bound) a mapping index from the IP DSCP to 802.1D table should be specified. The mapping index, in both cases, depends on the number
of mappings configured by the user. For SpectraLink policy type a mapping is not required.
Specifying the Mapping between 802.1p and 802.1D Priorities
The QoS 802.1p to 802.1D Mapping Table specifies the mapping between 802.1P and 802.1D priorities.
Specifying the Mapping between IP Precedence/DSCP Ranges and 802.1D Priorities
The QoS IP DSCP to 802.1D Mapping Table specifies the mapping between IP Precedence/DSCP Ranges and 802.1D
priorities.
Policy Type Integer inlayer2,
inlayer3,
outlayer2,
outlayer3,
spectralink*
RW type
Priority Mapping Index
†
Integer See Note
†
. RW mapindex
Apply QoS Marking Object Status enable
disable
RW markstatus
Table Row Status Row Status enable
disable
delete
RW status
Name Type Value Access CLI Parameter
QoS 802.1p to 802.1D
Mapping Table
Table N/A N/A qos1pto1dtbl
Table Index (Primary
Index)
Integer 0 - 7 R index
802.1D Priority
(Secondary Index)
Integer 0 - 7 R 1dpriority
802.1p Priority Integer 0 - 7 RW 1ppriority
Table Row Status Row Status enable
disable
delete
RW status
Name Type Value Access CLI Parameter
QoS IP DSCP to 802.1D
Mapping Table
Table N/A N/A qosdscpto1dtbl
Table Index (Primary
Index)
Integer 0 - 7 R index
802.1D Priority Integer 0 - 7 R 1dpriority
IP DSCP Lower Limit Integer 0 - 62 RW dscplower
IP DSCP Upper Limit Integer 1 - 63 RW dscpupper
Table Row Status Row Status enable
disable
delete
RW status
Name Type Value Access CLI Parameter