Filter
Top Products
User’s Guide • 4–3
Chapter 4 • Maintenance
CAUTION! The lamp module gets very hot during operation.
Use appropriate care when changing lamps. Make sure that the
lamp module has cooled for at least 3 to 5 minutes.
5. Grasp the handle located on the rear of the lamp module and
firmly pull the lamp module straight out.
Figure 4-3
Removing the lamp module
6. Replace the old lamp module with a new lamp module, care-
fully aligning the power pins on the bottom and pressing
firmly into place. When it is properly placed, a small align-
ment mark etched on the projector chassis will be visible below
the lamp module.
7. Screw the two lamp module retaining screws down flush.
8. Replace the service door and screw it into place.
9. Replace the power cord.
Cleaning the Air Filter
You should change or clean the air intake filter after every 100
operating hours to maintain proper cooling. This filter is located
on the bottom of the projector, under the grill.