Filter
Top Products
4 – Installation
Installing a Switch
4-14 59096-04 A
S
4.2.6
Configure the Switch
You can configure the switch using the CLI, QuickTools, or Enterprise Fabric Suite
2007. Enterprise Fabric Suite 2007 is an optional, full fabric graphical user
interface that comes with a 30-day trial license. Refer to the SANbox 5000 Series
Enterprise Fabric Suite 2007 User Guide for information about installing
Enterprise Fabric Suite 2007.
To log in and configure the switch using QuickTools, do the following:
1. Open an Internet browser and enter the default IP address 10.0.0.1 to start
the QuickTools web applet.
2. Log in to the switch using the default user name (admin) and password
(password).
3. Obtain the IP address and subnet mask from your network administrator.
4. Open the QuickTools Wizards menu and select Configuration Wizard.
Follow the instructions to set network parameters and the password.
Changing the IP address will terminate the QuickTools session.
5. Open an Internet browser again and log in with the new IP address.
The Configuration wizard prompts you for the following configuration information:
Table 4-2. Configuration Wizard Prompts
Temporary IP address
Temporary subnet mask
Archive template file
Switch domain ID (1–-239)
Domain ID Lock (Locked/Unlocked)
Switch name
Permanent IP address
Permanent subnet mask
Permanent gateway address
Permanent network discovery method
Date and time
Admin account password
Create a configuration archive?